Home
FAQ
Search
Register
Memberlist
Usergroups
Log instainless steel
Re: stainless steel
by xrayboy on Tue Sep 30, 2008 6:01 pm
there isnt a easy way to cut stainless how thick is it and is it a screw ?
normall when you cut a 3mm stainless steel screw u will do about 2-3 junior hack saw baldes
normall when you cut a 3mm stainless steel screw u will do about 2-3 junior hack saw baldes
xrayboy- Number of posts: 127
Age: 17
Location: REEVES MODELS BH*DESIGNS GM-RACING
Registration date: 2007-11-12 
Re: stainless steel
by tsr on Wed Oct 01, 2008 7:39 am
no its plate about 1mm thick.thought cut to size of lipo pack would be heavier and thinner than lead.how about a dremel
tsr- Number of posts: 118
Age: 53
Registration date: 2007-08-30 -
MR G.M.C.C.- Moderator
- Number of posts: 1397
Age: 37
Location: *G.M.C.C.*MUCH-MORE RACING U.K*TOP RACING-SCYTHE*RICH PAINT*
Registration date: 2007-08-29 -
Re: stainless steel
by xrayboy on Thu Oct 02, 2008 6:31 pm
u wil dol a few dremal bits tho and are you sure lead is heavier :S
xrayboy- Number of posts: 127
Age: 17
Location: REEVES MODELS BH*DESIGNS GM-RACING
Registration date: 2007-11-12 -
Re: stainless steel
by tsr on Thu Oct 02, 2008 7:58 pm
no im not sure which is heavier.if it was easy to cut id find out.how many hacksaw blades to cut a piece 135x45 LOL
tsr- Number of posts: 118
Age: 53
Registration date: 2007-08-30 -
Re: stainless steel
by xrayboy on Fri Oct 03, 2008 10:52 pm
lots lol there only cheap tho but im pretty sure lead will still be heavier lol
xrayboy- Number of posts: 127
Age: 17
Location: REEVES MODELS BH*DESIGNS GM-RACING
Registration date: 2007-11-12 -
Permissions of this forum:
You cannot reply to topics in this forum