Did I Kill My 13.5 brushless motor?

Sorted Thanx to Mark

Motor Still in good working order but there is something like a Glue melted on magnet...
Is that means the beginning of the end

If ti still works then I think you should be ok, when I run my 13.5 bonded I run on 8.10, what gearing were you running that on? it looks like you were over gearded and it has got to hot, do you run a fan on your motor?

no fan no heatsink 20/89 spur 8 overall still runs ok I just take it a part to clean and see that
Thanx for quick reply ...

I this an Orion 13.5 sintered? if so I would run it on about 8.30, give it a clean and go down 1 tooth. I would use a fan though.

It is really confusing On rctech they think Motor is undergeared... ,most people use it around 4.3-4.9-5
Novak says for their motors use 2-3 tooth higher pinion than stock brushed I was using 16 but I think It should be 15 I reckon so 3 tooth higher comes to 18 or 19 but still not sure what to do
"looks like pulled a winding from the soldered terminals"
"Look at the second picture. Next to the holes in the ring you can see where the windings are soldered on. The one at the top has come partially unsoldered (probably from over heating) if you look down into the motor from that unsoldered joint you can see what looks like a fracture in the iron core the windings are around.(Maybe what caused the overheating?)"
p.s two different users opinions...

I looked at the 2nd pic and it does look like it has come unsoldered .
I think some drivers at the grays club which is a bit smaller than our track had a few drivers gearing the car to high for such a small track and they had motors running to hot and overheating.
It's hard to say if you were under or over geared without driving the car or watching it.

Thanx Mark
Sold Now! I hope new owner knows the gearing
It is still in good working order but I can't live with suspicions LOL
So what make brushless motor is the BEST ?
Cheers

Luke Bennet might still be selling a goooood 13.5 motor pm him

No Thanx LOL
They are not that expensive anyway

I use a bonded 13.5 Nosram at our club which are £39.99.
But most say the Novaks are the best, not sure though as the lrp/nosram vectors are very good too.