brushed 19t

got 1 to sell.or which wood you recommend.cheers boys

I always used checkpoint 19t's they were very reliable.

the orion or peak 19ts were also very good but did blow a lot.

think they would be a bit to quick for you try a brushless 13.5 its quicker than a 27t stock and you can gear them a lot higher. Move into the future lol.

I always ran the lay down dynasty motor from peak. As it was quick and easy to use, I used the puknum brushes (how ever you spell it!lol), but used 2 sets for the day depending on how good i was placed!lol I was using a freshly skimed motor every run to get the best out of it and in the end, ended up having 4/5 motors all skimmed at the begining of the day, and rotated the arm and the can, keeping the same endbell with the same brushes for the day! (then changed the brushes for the last do or die qualifing run or for the final, if it was any good?lol)

If you want less brush wear go for the V2 type endbell! You can get away with a few runs before skimming it, and the brushes dont seem to ware that much, but for best results always skim it every run! - With the v2 endbell you will need to gear it up 3 teeth on the pinion. I used this motor for open pratice so I could get out for 2 or more runs with out changing the motor!

Hope this helps!

Or go and get brushless system - no hasel then!lol